ι Installation of umbrella cover
Umbrella cover dismantling
You can dismantle the parasol replacement cover in four steps.
- Remove the screw on the sunshade (Phillips screw or Allen, depending on the model). To do this, open the screen slightly so that there is enough space for the screwdriver.
- Now open the Velcro on the umbrella and on the inside of the poles.
- With the umbrella folded, pull the ends out of the poles.
- Open the cap at the top. Screw until the cap can be completely removed. Now you can remove the umbrella cover.
Please note the following instructions for assembly!
Step 1:
Step 2:
Step 3:
Step 4:
Remove the replacement Seglaro parasol cover
Umbrella cover assembly
You can also reinstall the replacement umbrella cover in four steps. Please note the important information!
- Fold the umbrella until it is closed is. So that the tabs can be mounted more easily. A replacement cover cannot be fitted when the sunshade is open!
- Place the replacement cover over the parasol rods with the Velcro opening towards the parasol rod and fix the parasol cover in place. Do not fix the plastic cap at the upper end yet, so that the pockets from the spare cover are easier to mount in the rod ends!
- The Fastening screw at the eyelet at the end of the Velcro screw on. Now put the rod ends in the pockets. This should be possible with some tension. Start at thread with the 4 outer corner bars, after that which makes 4 slightly shorter bars on the sides thread.
ATTENTION: Do not use force, otherwise the seam or fabric may tear!
4. If you have now threaded all 8 straps into the linkage, you can now, as with disassembly, Screw on the cap centrally at the upper end. At the inside from the umbrella cover, please Velcro closures on the four outer bars as well attach.
Step 1:
Step 2:
Step 3:
Step 4:
Fastening the tabs if necessary
At the end, check whether all the tabs in the linkage are threaded properly. With prolonged use, the tabs may eventually detach from the pockets when folded. If this happens frequently, you can attach the tabs to the end of the bar with a screw and washer to keep it permanently attached. Washers and screws are not included in the scope of delivery (you can get them in every Bauhaus, Spark screw M3 or M4 + corresponding washer).
Note
Please follow the care instructions for the replacement cover to increase the lifespan of the cover.
The lifespan of the cover can be significantly extended when using a protective cover. You can find our range of protective cases in our Shop.